Run the TaskManager project in your preferred IDE and use the Debug button on the task's menu.

You may debug any task, either a data mining task or a trading task by following these steps.

Start Here

1. Run your Superalgos node in the usual manner.

2. Open the TaskServer project in your preferred IDE, place a breakpoint in the part of the code you wish to debug, and run the TaskServer.

3. Click the Debug button on the menu of the task you wish to debug. The request will be routed to the TaskServer running in your IDE.

Click the Debug button on the task menu.

4. Run the trading session in case it is a trading task.

After a few seconds, execution should pause in the line where you put the breakpoint. Bear in mind the system runs slower in debug mode, thus, it may take a little while for the session to start processing, after loading all dependencies.